Fujitsu Eternus DX90 S2 매뉴얼 - 페이지 10

{카테고리_이름} Fujitsu Eternus DX90 S2에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu Eternus DX90 S2 18 페이지. Server connection. (fibre channel) for aix
Fujitsu Eternus DX90 S2에 대해서도 마찬가지입니다: 사용자 설명서 (35 페이지), 사용자 설명서 (42 페이지), 설치 설정 (20 페이지), 수동 서버 연결 구성 (13 페이지), 하드웨어 설치 (23 페이지), 구성 매뉴얼 (28 페이지), 구성 매뉴얼 (15 페이지), 구성 매뉴얼 (38 페이지)

페이지 인쇄
Fujitsu Eternus DX90 S2 매뉴얼
Cable Connection
S T E P
Various cables need to be connected to the rear of the ETERNUS DX Disk storage system.
●
Point
●
The cables should never be bent, twisted or pulled.
IMPORTANT
LAN Cable (for Operation Management)
Connect a LAN cable (for operation management) to each MNT port.
Cable
-Installation- "4.1 LAN Cable Connection (For Operation Management)"
Host Interface Cable
Connect a Host Interface cable to each of these ports.
Cable
FC, iSCSI 10Gbit/s, FCoE
●
(for FC cable connection)
iSCSI 10Gbit/s, FCoE
●
(for Copper Twinax cable
connection)
1Gbit/s iSCSI
●
SAS
●
-Installation- "4.2 Host Interface Connection"
To help with cable management and prevent incorrect connection, attach labels to the cables and make a
note of connection origins and destinations.
This step describes dual controller type as an example. Note that there is only controller 0 (CM#0) for single
controller type.
Rear view
Rear view
1Gbit/s iSCSI
ETERNUS DX80 S2/DX90 S2 Disk storage system Read Me First
Copyright 2013 FUJITSU LIMITED
Controller (CM#0)
RMT port
MNT port
CA#0
CA#1
FC, iSCSI 10Gbit/s, FCoE
(for FC cable connection)
Port#0
Port#1
Port#0 Port#1
10
Controller (CM#1)
Controller enclosure
RMT port
MNT port
CA#0
CA#1
Controller enclosure
iSCSI 10Gbit/s, FCoE
(for Copper Twinax cable connection)
Port#0
Port#1
SAS
Port#0
Port#1
P3AM-4872-11EN