Fujitsu Eternus DX90 S2 매뉴얼 - 페이지 12

{카테고리_이름} Fujitsu Eternus DX90 S2에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu Eternus DX90 S2 18 페이지. Server connection. (fibre channel) for aix
Fujitsu Eternus DX90 S2에 대해서도 마찬가지입니다: 사용자 설명서 (35 페이지), 사용자 설명서 (42 페이지), 설치 설정 (20 페이지), 수동 서버 연결 구성 (13 페이지), 하드웨어 설치 (23 페이지), 구성 매뉴얼 (28 페이지), 구성 매뉴얼 (15 페이지), 구성 매뉴얼 (38 페이지)

페이지 인쇄
Fujitsu Eternus DX90 S2 매뉴얼
Power Cords
Connect the power cords to the inlets of the power supply unit.
Use release ties to hold the power cords in place.
Cable
-Installation- "4.5 Power Cord Connection"
Basic Setup
S T E P
Use ETERNUS Web GUI to perform a basic setup of the ETERNUS DX Disk storage system.
ETERNUS DX Disk Storage System and PC Terminal Connection
Connect a PC terminal to the ETERNUS DX Disk storage system.
Connect the PC terminal to the MNT port of Controller 0 (CM#0) on the controller enclosure directly with the LAN
cable (for operation management).
LAN port
PC terminal
●
IMPORTANT
●
-Installation- "5.1.1 ETERNUS DX Disk Storage System and PC Terminal Connection"
Powering On
Turn on the PC terminal and the ETERNUS DX Disk storage system.
When turning on the ETERNUS DX Disk
IMPORTANT
storage system for the first time, volume
formatting operation, which is set as factory
default, may be performed. However, the
ETERNUS DX Disk storage system setting
operation can be continued.
-Installation- "5.1.2 Powering On"
Rear view
LAN cable
MNT port of Controller 0 (CM#0)
When the LAN cable for the MNT port of Controller 0 (CM#0) is connected to a network device, connect the
cable to a PC terminal.
Remove the LAN cable that is connected to the MNT port of Controller 1 (CM#1).
ETERNUS DX80 S2/DX90 S2 Disk storage system Read Me First
Copyright 2013 FUJITSU LIMITED
Controller enclosure
Power switch
12
Drive enclosure 1
Controller enclosure
Drive enclosure
Drive enclosure
Controller enclosure
P3AM-4872-11EN