Fujitsu Eternus DX90 S2 Panduan Konfigurasi - Halaman 18

Jelajahi secara online atau unduh pdf Panduan Konfigurasi untuk Penyimpanan Fujitsu Eternus DX90 S2. Fujitsu Eternus DX90 S2 28 halaman. Server connection. (fibre channel) for aix
Juga untuk Fujitsu Eternus DX90 S2: Panduan Pengguna (35 halaman), Panduan Pengguna (42 halaman), Manual (18 halaman), Instal Pengaturan (20 halaman), Konfigurasi Manual Koneksi Server (13 halaman), Instalasi Perangkat Keras (23 halaman), Panduan Konfigurasi (15 halaman), Panduan Konfigurasi (38 halaman)

Chapter 6

Installing the iSCSI Software Initiator and Setting Up the Server

6.2

Setting Up the Server

Confirm the iSCSI Initiator name.

Use the "iscsiutil" command to check the iSCSI Initiator name.

The iSCSI Initiator name shown here is used for the ETERNUS DX settings.

# iscsiutil -l

Save the statically-recognized iSCSI target information in the kernel registry.

Use the "iscsiutil" command to save the iSCSI target information.

# iscsiutil [iscsi-device-file] -a -I <ip-address>

Example:

For an ETERNUS DX with a connection target iSCSI port IP address of 192.1.1.120:

# iscsiutil -a -I 192.1.1.120

Confirm the iSCSI target information is now in the kernel registry.

# iscsiutil -p -D

Set whether CHAP authentication is to be used or not.

If CHAP authentication is to be performed, set "CHAP". If CHAP authentication is not required, set

"None".

Example:

When CHAP authentication is not used:

# iscsiutil -t authmethod None

Note:

# iscsiutil -t authmethod CHAP None

The above command sets CHAP authentication to operate according to the ETERNUS DX setting. The

CHAP authentication method is selected if the ETERNUS DX uses CHAP for its responses, otherwise CHAP

authentication is not performed.

FUJITSU Storage ETERNUS DX Configuration Guide -Server Connection- (iSCSI) for HP-UX

[-P <tcp-port>][-M <portal-grp-tag>]

P3AM-3402-14ENZ0