AEG ProSense LF694ABC Panduan Pengguna - Halaman 10
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Mesin cuci AEG ProSense LF694ABC. AEG ProSense LF694ABC 40 halaman.
Halaman Cetak4. Connect the water inlet hose to the cold
water tap with 3/4" thread.
WARNING!
The inlet water shall not exceed 25 °C.
CAUTION!
Make sure that there are no leaks from
the couplings.
Do not use an extension hose if the inlet
hose is too short. Contact the service
centre for the replacement of the inlet
hose.
5.4 Water-stop device
The inlet hose has a water stop device. This
device prevents water leaks in the hose
because of its natural ageing.
The red sector in the window «A» shows this
fault.
A
If this occurs, close the water tap and contact
the authorized service centre to replace the
hose.
5.5 Water drainage
The drain hose should be positioned at a
height of not less than 60 cm and not more
than 100 cm from the floor.
10
ENGLISH
You can extend the drain hose to
maximum 400 cm. Contact the
authorized service centre for the other
drain hose and the extension.
It is possible to connect the drain hose in
different ways:
1. Make a U shape with the drain hose and
put it around the plastic hose guide.
2. On the edge of a sink - Fasten the guide
to the water tap or to the wall.
Make sure that the plastic guide cannot
move when the appliance drains.
Make sure that the drain hose end is not
immersed in the water. There may be a
return of dirty water into the appliance.
3. To a stand pipe with vent-hole - Insert
the drain hose directly into a drain pipe.
Refer to the illustration.