Brother MFC490CW - Color Inkjet - All-in-One Manual Koneksi - Halaman 2
Jelajahi secara online atau unduh pdf Manual Koneksi untuk Perangkat lunak Brother MFC490CW - Color Inkjet - All-in-One. Brother MFC490CW - Color Inkjet - All-in-One 6 halaman. Mac network connection
Juga untuk Brother MFC490CW - Color Inkjet - All-in-One: Panduan Pengaturan Cepat (48 halaman), Panduan Pengaturan Cepat (47 halaman), Pengaturan & Pemasangan (5 halaman), Petunjuk Perbaikan (2 halaman)
![Brother MFC490CW - Color Inkjet - All-in-One Manual Koneksi](/uploads/products/server2/2458849/2458849.png)
MFC490CW Vista Network Connection Repair Instructions
f.
If the number of packets sent DOES NOT equal the number of packets received, then there is
a communication problem between the Brother machine and the Computer. Attempt to
reestablish communication by completing the following steps:
i.
Set boot method to Auto. This is necessary so that the Brother machine can attempt
to obtain a valid IP address from your router or access point.
ii.
Press MENU
iii.
Scroll to NETWORK and press OK.
iv.
Scroll to WLAN and press OK.
v.
Scroll to TCP/IP and press OK.
vi.
Scroll to BOOT METHOD and press OK.
vii.
Scroll to AUTO and press OK, and then press STOP/EXIT.
viii.
Turn the Brother machine off, wait approximately 30 seconds and power the Brother
machine back on. Repeat Part 3 Step 2 again.
g. If the number of packets sent equals the number of packets received, then this indicates there
is communication between the Brother machine and the Computer. Continue to the next step.
PART 4: VERIFY THAT THE PRINTER DRIVER IS INSTALLED
1. On the computer Click START -> RUN
2. Type: CONTROL PRINTERS and click OK.
3. Verify that the Brother printer is in the list. If the Brother printer is listed, continue on. If the Brother
printer is not listed, the driver may not be installed properly. Skip to PART 8 to reinstall the Brother
driver.
4. Verify that the Brother printer is set as default. This is especially important if you use the print icon to
print from within applications. If the Brother printer is set as the default printer, it will have a check
mark in front of the icon. To set your Brother machine as the default printer, RIGHT CLICK on the
Brother printer and select SET AS DEFAULT (PRINTER).
PART 5: VERIFY THAT THE PRINTER STATUS IS READY AND THE PRINT QUEUE IS EMPTY
1. Click on START -> RUN
2. Type: CONTROL PRINTERS and click OK.
3. Locate the Brother printer in the list and hover your mouse over the Brother printer icon. Below is an
example of what you may see:
Status: Ready (Could also state: USE PRINTER OFFLINE or PAUSED)
Documents: 0 (Could be any number)
4. If there are any documents waiting in the queue, right-click on the Brother printer and select CANCEL
ALL DOCUMENTS. This should clear the queue.
5. If the status states:
PRINTER OFFLINE: right-click on the Brother printer and uncheck USE PRINTER OFFLINE or select
USE PRINTER ONLINE depending on your operating system. This should set the printer driver
ONLINE.
PAUSED: right-click on the Brother printer and uncheck PAUSE PRINTING or click RESUME PRINTING
depending on your operating system. This should allow the printer to resume printing.
PART 6: CHECK THE DRIVER PORT SETTINGS:
1. Click on START -> RUN
2
© 1995 - 2010 Brother International Corporation
www.brother-usa.com