Fujitsu Stylistic LT C-500 Panduan Instalasi - Halaman 2

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Tablet Fujitsu Stylistic LT C-500. Fujitsu Stylistic LT C-500 4 halaman. Screen protector
Juga untuk Fujitsu Stylistic LT C-500: Panduan Pengguna (2 halaman), Petunjuk Pengguna (1 halaman), Panduan Pengguna (8 halaman), Petunjuk Instalasi (1 halaman), Panduan Pengguna (2 halaman), Petunjuk Instalasi (1 halaman), Panduan Instalasi (1 halaman), Petunjuk (4 halaman), Petunjuk Instalasi (1 halaman)

SerialAdapter.fm Page 2 Monday, August 27, 2001 9:03 AM

3. Remove the plastic cover that is located over the system

interface port on the bottom edge of the pen tablet. Keep

the cover in a safe place for future reinstallation.

4. Plug the serial adapter into the system interface port.

The plug is keyed so that it will only fit when it is posi-

tioned properly (see Figure 3).

5. Insert the serial plug into the serial connector (see Figure

2).

6. Restart the system and the serial device.

To remove the adapter,

1. If the pen tablet is running, either suspend operation or

power down the system.

2. If the serial device you wish to disconnect has power

applied, remove power.

3. Pull the plug from the connector. Replace the plastic

cover over the system interface port.

4. Restart your system.

Note: When the serial adapter is attached to the pen tablet,

the tablet cannot be used in the compact desk stand

because the connector/cable assembly extends too far

from the bottom of the system. The system should be

held or laid flat when the serial adapter is installed.