Fujitsu Stylistic LT C-500 설치 매뉴얼 - 페이지 2

{카테고리_이름} Fujitsu Stylistic LT C-500에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu Stylistic LT C-500 4 페이지. Screen protector
Fujitsu Stylistic LT C-500에 대해서도 마찬가지입니다: 사용자 설명서 (2 페이지), 사용자 지침 (1 페이지), 사용자 설명서 (8 페이지), 설치 지침 (1 페이지), 사용자 설명서 (2 페이지), 설치 지침 (1 페이지), 설치 매뉴얼 (1 페이지), 지침 (4 페이지), 설치 지침 (1 페이지)

페이지 인쇄
Fujitsu Stylistic LT C-500 설치 매뉴얼
SerialAdapter.fm Page 2 Monday, August 27, 2001 9:03 AM
3. Remove the plastic cover that is located over the system
interface port on the bottom edge of the pen tablet. Keep
the cover in a safe place for future reinstallation.
4. Plug the serial adapter into the system interface port.
The plug is keyed so that it will only fit when it is posi-
tioned properly (see Figure 3).
5. Insert the serial plug into the serial connector (see Figure
2).
6. Restart the system and the serial device.
To remove the adapter,
1. If the pen tablet is running, either suspend operation or
power down the system.
2. If the serial device you wish to disconnect has power
applied, remove power.
3. Pull the plug from the connector. Replace the plastic
cover over the system interface port.
4. Restart your system.
Note: When the serial adapter is attached to the pen tablet,
the tablet cannot be used in the compact desk stand
because the connector/cable assembly extends too far
from the bottom of the system. The system should be
held or laid flat when the serial adapter is installed.
2