Fujitsu SK-91460T-144PMC-GPIO Panduan Pengguna - Halaman 25
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Motherboard Fujitsu SK-91460T-144PMC-GPIO. Fujitsu SK-91460T-144PMC-GPIO 47 halaman. Mb91460 series
Halaman Cetak
4 Connectors
4.1 Power connector (X6)
The following figure shows the power connection jack X6. This connector is used to connect
an external unregulated DC power supply voltage (9V-15V DC) to the evaluation board.
Connector X6:
The switching mode voltage regulators allow a wide input range. This might be of interest
when using Vin to power the LIN bus Vs line.
4.2 Edge connector (J1, J2, J3, J4)
All pins (except oscillator Pins) of the microcontroller are directly connected to J1 to J4 as
follows:
The odd pin numbers are located on the one side and the even pin numbers are located on
the other side of the connector.
© Fujitsu Microelectronics Europe GmbH
SK-91460T-144PMC-GPIO User Guide
Chapter 4 Connectors
Shield is connected to GND
+
Center is connected to positive voltage supply (+)
Figure 4-1: Power Connector
Connector
J1
J2
J3
J4
- 25 -
MCU Pins
1 – 36
37 – 72
73 – 108
109 – 144
FMEMCU-UG-910074-11