Fujitsu SK-91460T-144PMC-GPIO 사용자 설명서 - 페이지 25
{카테고리_이름} Fujitsu SK-91460T-144PMC-GPIO에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu SK-91460T-144PMC-GPIO 47 페이지. Mb91460 series
페이지 인쇄
4 Connectors
4.1 Power connector (X6)
The following figure shows the power connection jack X6. This connector is used to connect
an external unregulated DC power supply voltage (9V-15V DC) to the evaluation board.
Connector X6:
The switching mode voltage regulators allow a wide input range. This might be of interest
when using Vin to power the LIN bus Vs line.
4.2 Edge connector (J1, J2, J3, J4)
All pins (except oscillator Pins) of the microcontroller are directly connected to J1 to J4 as
follows:
The odd pin numbers are located on the one side and the even pin numbers are located on
the other side of the connector.
© Fujitsu Microelectronics Europe GmbH
SK-91460T-144PMC-GPIO User Guide
Chapter 4 Connectors
Shield is connected to GND
+
Center is connected to positive voltage supply (+)
Figure 4-1: Power Connector
Connector
J1
J2
J3
J4
- 25 -
MCU Pins
1 – 36
37 – 72
73 – 108
109 – 144
FMEMCU-UG-910074-11