2N Lift8 Panduan Singkat - Halaman 6

Jelajahi secara online atau unduh pdf Panduan Singkat untuk Unit Kontrol 2N Lift8. 2N Lift8 12 halaman. Io module
Juga untuk 2N Lift8: Panduan Singkat (8 halaman), Panduan Singkat (13 halaman), Panduan Singkat (14 halaman), Panduan Singkat (6 halaman), Panduan Singkat (12 halaman), Panduan Singkat (17 halaman)

Programming:

Before you start programming



Use the prepared form, which is also a clear table of basic functions, and fill in all the

values you want to change.



If the L8 is not brand new, make sure that you have the correct servicing password,

and if you are not completely sure how the L8 is programmed, always use full

initialisation (Attention: The servicing password is also initialised!).



The L8 can be programmed in 3 ways: remotely by telephone (using the telephone

number), using the machine room audio unit, and or using the service tool program

(connection via USB or using an IP address).

Entry to programming mode

You can enter the programming mode during an incoming connection (calling the L8's

number) or using the machine room audio unit (by pressing

seconds).

Using the voice menu you get through to programming (For administration press 9 ->

For entry to the programming menu press 1).

You are called upon to enter the servicing password in the format servicing password

(don't forget to enter the asterisk after the password).

If the entered password is correct, L8 announces:

"You have entered the programming menu, select the parameter"

The factory setting of the password is 12345, and we recommend that you enter a

different password so that your equipment is protected from other people.

Actual programming

As soon as you have entered the programming mode, you can change any programmable

value or several values, and you can do so in any order. The procedure is simple – first

the number of the function is entered, then its value. An asterisk serves as a separator or

"enter". So in general terms the function has the following format:

The number of the function has three digits (see table). After entering this number and

the asterisk, L8 announces the number of this parameter, its current value and possible

range. After entering the value and the second asterisk, L8 announces "The new value

has been saved" or "Invalid value, the new value has not been saved" if the value falls

outside the permitted range.

For control purposes L8 reads out the number of the parameter and the newly configured

value.

number of function

for longer than 2

value