2N Lift8 Panduan Singkat - Halaman 10
Jelajahi secara online atau unduh pdf Panduan Singkat untuk Unit Kontrol 2N Lift8. 2N Lift8 14 halaman. Io module
Juga untuk 2N Lift8: Panduan Singkat (8 halaman), Panduan Singkat (12 halaman), Panduan Singkat (13 halaman), Panduan Singkat (6 halaman), Panduan Singkat (12 halaman), Panduan Singkat (17 halaman)
Halaman Cetak
LED indicators
The camera module is equipped with seven LED indicators; see the table below.
Name
Colour
The LED is flashing while images are being recorded on the microSD card.
SD
Orange
When the LED is on, you can slide the microSD card out by pressing the
REC/STOP button.
REL
undefined not implemented
The LED is flashing to indicate that the bus is connected and the camera
module is communicating with the CU. The LED is illuminated when an alarm
call is being set up. The LED is flashing quickly when a camera image is being
OK
Green
loaded during an alarm call.
The LED lights up for a moment to indicate bus connection. The LED is
flashing slowly to indicate a collision with another module (make sure that
ERR
Red
just one camera module is connected for the given shaft).
The LED is on when the camera is connected and configured properly. The
ETH
Orange
LED is flashing to indicate active recording.
The LED is on when the camera is connected and configured properly. The
232
Orange
LED is flashing to indicate active recording.
The LED is on when the camera is connected and configured properly. The
485
Orange
LED is flashing to indicate active recording.
Caution
The OK LED is flashing and ERR LED is illuminated when the unit is being
upgraded.
Caution
®
Use the 2N
parameters.
Camera Module Setting
Set the 2N® Lift8 camera module via the 2N® Lift8 Service Tool. Refer to 5.3 Use for
details.
Lift8 Service Tool application to set the camera type and other
Description
9