A-Neuvideo HD-44G Buku Petunjuk - Halaman 2

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Beralih A-Neuvideo HD-44G. A-Neuvideo HD-44G 6 halaman. Ethernet (tcp) set up
Juga untuk A-Neuvideo HD-44G: Buku Petunjuk (20 halaman), Buku Petunjuk (20 halaman)

Halaman Cetak
A-Neuvideo HD-44G Buku Petunjuk
INTRODUCTION
The Ethernet port (TCP) allows control of the unit via a computer by redirecting serial commands (COM port) to the unit's IP address. To
do this, you must:
(1) Install the unit and your computer on the same sub-network . (Step 1~4)
(2) Locate the Routing Control software on the supplied CD and install it on the computer. (Step 5)
Follow the steps below and you will be able to use the AP to control the unit. The default IP address of the unit is 192.168.1.3. If your PC is
not on the same sub-net, you must fi rst change your computer's IP address to allow access to the unit. Once this is done, you can change
the IP address of the unit and then restore your computer's IP address.
A-Neuvideo products with Ethernet port are designed for remote control on a network using our included GUI software. The Ethernet port
is not a web server for direct access via a web browser.
INTRODUCTION
1