A-Neuvideo HD-44G 사용 설명서 - 페이지 2

{카테고리_이름} A-Neuvideo HD-44G에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. A-Neuvideo HD-44G 6 페이지. Ethernet (tcp) set up
A-Neuvideo HD-44G에 대해서도 마찬가지입니다: 사용 설명서 (20 페이지), 사용 설명서 (20 페이지)

페이지 인쇄
A-Neuvideo HD-44G 사용 설명서
INTRODUCTION
The Ethernet port (TCP) allows control of the unit via a computer by redirecting serial commands (COM port) to the unit's IP address. To
do this, you must:
(1) Install the unit and your computer on the same sub-network . (Step 1~4)
(2) Locate the Routing Control software on the supplied CD and install it on the computer. (Step 5)
Follow the steps below and you will be able to use the AP to control the unit. The default IP address of the unit is 192.168.1.3. If your PC is
not on the same sub-net, you must fi rst change your computer's IP address to allow access to the unit. Once this is done, you can change
the IP address of the unit and then restore your computer's IP address.
A-Neuvideo products with Ethernet port are designed for remote control on a network using our included GUI software. The Ethernet port
is not a web server for direct access via a web browser.
INTRODUCTION
1