Kohler BodySpa K-1000 Panduan Pemilik Rumah - Halaman 7
Jelajahi secara online atau unduh pdf Panduan Pemilik Rumah untuk Perlengkapan Kamar Mandi Kohler BodySpa K-1000. Kohler BodySpa K-1000 48 halaman. Tower custom hydro-massage system
Juga untuk Kohler BodySpa K-1000: Panduan Petunjuk Instalasi (28 halaman)
Halaman Cetak
Using the Remote
The remote control places the user keypad functions at your fingertips to further enhance your
hydro-massage experience. The functions of the remote are identical to the user keypad. You may
turn the system on and off, turn the heater on and off, and access/modify all hydro-massage
functions.
The mode selector button functions in the same way as the outer ring. When "M" is pressed, one of
the modes will flash on the user keypad. If "M" is pressed again, the next mode in clockwise order
will flash. When the desired mode is flashing, press "OK" to activate it.
When the bodyjets or waterfall mode is active, the arrows will increase or decrease the water flow
volume for the selected mode.
The waterproof remote control is designed to be used in the bath and will float in the water.
Two AAA batteries are used in the remote control. To replace, simply unscrew the end cap and
insert the batteries, as shown above. Tighten the end cap securely, making sure the end cap makes
contact with the seal.
Programming the Remote
IMPORTANT! Programming the remote control is required. Your whirlpool will not respond to any
remote control until you program the remote. If you replace the remote control, or replace the pump
control, it will be necessary to program the remote control.
Turn the whirlpool power on.
Turn off all modes of operation. Wait approximately one minute until the keypad darkens
completely (Sleep mode).
On the user keypad, press the UP arrow, DOWN arrow, and the "OK" buttons simultaneously. The
bottom LED on the keypad's indicator bar will begin flashing.
While the LED is flashing, press the "OK" button on the keypad. A light sequence will illuminate up
and down the indicator bar.
While the indicator bar light sequence is active, press any button on the remote control. The keypad
will stop the light sequence, perform a download, and then darken. This user keypad will only
respond to this remote.
NOTE: If you do not press any of the buttons on the remote within two minutes the whirlpool will not
respond to the remote control.
Kohler Co.
Activates
Mode Selected
Mode
Selector
Power
Increases
Flow
Decreases
Flow
7
1030200-5-B