Kohler BodySpa K-1000 주택 소유자 매뉴얼 - 페이지 7

{카테고리_이름} Kohler BodySpa K-1000에 대한 주택 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Kohler BodySpa K-1000 48 페이지. Tower custom hydro-massage system
Kohler BodySpa K-1000에 대해서도 마찬가지입니다: 설치 지침 매뉴얼 (28 페이지)

페이지 인쇄

Using the Remote

The remote control places the user keypad functions at your ﬁngertips to further enhance your

hydro-massage experience. The functions of the remote are identical to the user keypad. You may

turn the system on and off, turn the heater on and off, and access/modify all hydro-massage

functions.

The mode selector button functions in the same way as the outer ring. When "M" is pressed, one of

the modes will ﬂash on the user keypad. If "M" is pressed again, the next mode in clockwise order

will ﬂash. When the desired mode is ﬂashing, press "OK" to activate it.

When the bodyjets or waterfall mode is active, the arrows will increase or decrease the water ﬂow

volume for the selected mode.

The waterproof remote control is designed to be used in the bath and will ﬂoat in the water.

Two AAA batteries are used in the remote control. To replace, simply unscrew the end cap and

insert the batteries, as shown above. Tighten the end cap securely, making sure the end cap makes

contact with the seal.

Programming the Remote

IMPORTANT! Programming the remote control is required. Your whirlpool will not respond to any

remote control until you program the remote. If you replace the remote control, or replace the pump

control, it will be necessary to program the remote control.

Turn the whirlpool power on.

Turn off all modes of operation. Wait approximately one minute until the keypad darkens

completely (Sleep mode).

On the user keypad, press the UP arrow, DOWN arrow, and the "OK" buttons simultaneously. The

bottom LED on the keypad's indicator bar will begin ﬂashing.

While the LED is ﬂashing, press the "OK" button on the keypad. A light sequence will illuminate up

and down the indicator bar.

While the indicator bar light sequence is active, press any button on the remote control. The keypad

will stop the light sequence, perform a download, and then darken. This user keypad will only

respond to this remote.

NOTE: If you do not press any of the buttons on the remote within two minutes the whirlpool will not

respond to the remote control.

Kohler Co.

Activates

Mode Selected

Mode

Selector

Power

Increases

Flow

Decreases

Flow

1030200-5-B