AEG LAVATHERM 96699IH Panduan Pengguna - Halaman 30

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Pengering AEG LAVATHERM 96699IH. AEG LAVATHERM 96699IH 32 halaman. Aeg tumble dryer

Halaman Cetak

INSTALLATION

APPLIANCE POSITIONING

• The tumble dryer must be installed in

a clean position, where dirt does not

collect.

• Air must flow freely around the appli-

ance. Make sure that the front airflow

slots in the bottom of the appliance

are not blocked .

• To keep vibration and noise at the

minimum, when the tumble dryer op-

erates, it must be put on a stable and

flat surface.

• When the appliance is put in its per-

manent position, check if is fully level

with the aid of a spirit level. If it is

not, adjust the feet until it is.

• Do not remove the feet. Do not de-

crease the floor clearance through

thick carpets, bar of wood or equiva-

lent. This can increase the heat which

can cause interference with the oper-

ation of the appliance.

• The temperature of the hot

• When the tumble dryer oper-

• If it is necessary to move the

• The appliance must not be in-

air which occurs in the tumble

dryer can increase to 60 °C.

The appliance must not be in-

stalled on the floor which is

not resistant to high tempera-

tures.

ates, the room temperature

must not be lower than +5 °C

and higher than +35 °C. This

can cause unwanted effect on

the performance of the appli-

ance.

appliance, it must be moved

vertically.

stalled behind a lockable

door, a sliding door, a door

with a hinge on the opposite

side to that of the appliance

in such a way that a full open-

ing of the tumble dryer is re-

stricted.

UNPACKING

CAUTION!

Before use all parts of the transport

packaging must be removed.

To remove the polystyrene blockages:

1. Open the load door.

2. Pull 2 plastic hoses with the poly-

styrene blockages out from the

drum.

It is possible to adjust the height of the

tumble dryer. To do that adjust the feet

(see picture).

15mm