AEG LAVATHERM 96699IH Panduan Pengguna - Halaman 31

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Pengering AEG LAVATHERM 96699IH. AEG LAVATHERM 96699IH 32 halaman. Aeg tumble dryer

Halaman Cetak

INSTALLATION UNDER A

COUNTER

The appliance can be installed as free-

standing or below the kitchen counter

with correct space (see picture).

600 mm

> 850 mm

THE LOAD DOOR REVERSAL

The load door can be installed by the

user in the opposite side. It can help to

easily put and remove the laundry or if

there is a limit to install the appliance.

(see separate leaflet).

ELECTRICAL CONNECTION

• Connect the appliance to a groun-

ded socket. Refer to the applicable

electrical requirements.

• Make sure that the electrical data on

the rating plate agrees with the pow-

er supply.

• Always use a correctly installed

shockproof socket.

• Do not use multiple plugs and exten-

sion cables. There is a risk of fire.

• All replacements of power supply ca-

ble must be carried out by our Serv-

ice.

• Make sure not to squash or cause

damage to the mains plug and cable

behind the appliance.

• Do not pull the mains cable to dis-

connect the appliance. Always pull

the mains plug.

• The plug must be dry.

The data about mains voltage, type of

current and the necessary fuse are on

the rating plate and in the "TECHNI-

CAL INFORMATION" chapter. The rat-

ing plate is behind the load door (see

the "PRODUCT DESCRIPTION" chap-

ter).

The appliance has a power supply ca-

ble with plug fitted with 13 A fuse. If

necessary, replace the fuse in the plug

by 13 A ASTA BS 1363/A approved

fuse.

The wires in the power supply cable are

coloured as follow:

A) green and yellow - ground — earth

(E)

B) brown - live (L)

C) cord clamp

D) blue - neutral (N)

The green and yellow coloured wire

must be connected to the terminal with

E mark or the ground

green and yellow coloured terminal.

The blue coloured wire must be con-

nected to the terminal N or black col-

oured .

The brown coloured wire must be con-

nected to the terminal L or red col-

oured .

The wires of the cable must be no cut

or stray strands of wire present and the

cable clamp must be secure over the

outer sheath.

Permanent connection

The necessary condition of permanent

connection is to install a double-pole

isolating switch directly on the supply

terminals.

The type of switch must be correct for

the necessary load and must align with

applicable electrical requirements.

The switch must not break the yellow

and green coloured ground wire.

ENGLISH

mark or the