AEG TR8G83GW Panduan Pengguna - Halaman 23
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Pengering AEG TR8G83GW. AEG TR8G83GW 32 halaman.
Halaman Cetak
Error code
The mains supply is unstable.
EH0
If the display shows other error codes, deactivate and activate the appliance. If the
problem continues, contact the Authorised Service Centre.
In case of different problem with the tumble dryer check the table below for possible
solutions.
11.2 Troubleshooting
Problem
The tumble dryer is not connected
to the mains supply.
The door is open.
The tumble dry‐
er does not op‐
The On/Off button was not pushed. Push the On/Off button.
erate.
The Avvio/Pausa button was not
touched.
The appliance is in standby mode.
Incorrect program selection.
The filter is clogged.
Livello Asciugatura option was set
to
The load was too large.
Unsatisfactory
drying result.
The airflow slots are clogged.
There is some dirt on the humidity
sensor in the drum.
The dryness level was not set to
the desired level.
The condenser is clogged.
Possible cause
Possible cause
3)
pronto stiro .
Remedy
When the appliance is showing
EH0, please wait until main supply
is stable than press start. If the ap‐
pliance pause the cycle without
any indication then press the cycle
start. If the warning will occur
check the power cord / socket in‐
tegrity or main supply.
Remedy
Connect it to the mains socket.
Check the fuse in the fuse box (do‐
mestic installation).
Close the door.
Touch the Avvio/Pausa button.
Push the On/Off button.
Select a suitable program.
2)
Clean the filter.
Change Livello Asciugatura option
to a higher level.
Do not exceed the maximum load
size.
Clean the airflow slots at the bot‐
tom of the appliance.
Clean the front surface of the
drum.
Adjust the dryness level.
Clean the condenser.
ENGLISH
23
1)
4)
2)