AEG TR8G83GW Kullanıcı Kılavuzu - Sayfa 23

Kurutucu AEG TR8G83GW için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. AEG TR8G83GW 32 sayfaları.

Sayfayı Yazdır

Error code

The mains supply is unstable.

EH0

If the display shows other error codes, deactivate and activate the appliance. If the

problem continues, contact the Authorised Service Centre.

In case of different problem with the tumble dryer check the table below for possible

solutions.

11.2 Troubleshooting

Problem

The tumble dryer is not connected

to the mains supply.

The door is open.

The tumble dry‐

er does not op‐

The On/Off button was not pushed. Push the On/Off button.

erate.

The Avvio/Pausa button was not

touched.

The appliance is in standby mode.

Incorrect program selection.

The filter is clogged.

Livello Asciugatura option was set

The load was too large.

Unsatisfactory

drying result.

The airflow slots are clogged.

There is some dirt on the humidity

sensor in the drum.

The dryness level was not set to

the desired level.

The condenser is clogged.

Possible cause

pronto stiro .

Remedy

When the appliance is showing

EH0, please wait until main supply

is stable than press start. If the ap‐

pliance pause the cycle without

any indication then press the cycle

start. If the warning will occur

check the power cord / socket in‐

tegrity or main supply.

Remedy

Connect it to the mains socket.

Check the fuse in the fuse box (do‐

mestic installation).

Close the door.

Touch the Avvio/Pausa button.

Push the On/Off button.

Select a suitable program.

Clean the filter.

Change Livello Asciugatura option

to a higher level.

Do not exceed the maximum load

size.

Clean the airflow slots at the bot‐

tom of the appliance.

Clean the front surface of the

drum.

Adjust the dryness level.

Clean the condenser.

ENGLISH