Kohler BATH WALL Panduan Petunjuk Instalasi - Halaman 7
Jelajahi secara online atau unduh pdf Panduan Petunjuk Instalasi untuk Bak mandi Kohler BATH WALL. Kohler BATH WALL 9 halaman. Bath with airjets
Juga untuk Kohler BATH WALL: Manual Pengasahan Awal (Roughing-In) (4 halaman)
Halaman Cetak
DURACRYL WALL
DURACRYL WALL INSTALLATION CONT...
MARKING ADHESIVE PATTERN
Carefully measure and mark pattern on wall
board surface as shown in figure 11.
This pattern applies to:
Mark the pattern but do not
apply adhesive at this stage.
!
When applying adhesive
IMPORTANT
it is vital to leave gaps in the
bead to allow solvent curing.
NOTE: Measurements from edges, top and
base. All dimensions below are in millimeters.
For moulded shower walls, the pattern must be marked on both wall board and rear of Duracryl liner.
Refer to figures below for both patterns: • Corner Contour & Corner Contour PLUS Wall -
At this stage it is essential that the back side of the Duracryl wall and the surface of the wall board
are wiped clean with a damp cloth. This will ensure that all dust is removed from both surfaces and
provide a clean surface for the adhesive. Allow both surfaces to dry before adhesive application.
Fig.12: Adhesive pattern for Corner
Contour and Corner Contour PLUS Walls
300
80
Tray recess
Pattern on wall board
• Flat shower walls
• Flat bath walls
• The flat sections of
moulded walls
• Side Recessed Wall -
250
Pattern on rear of wall liner
INSTALLATION INSTRUCTIONS
Fig.11: Adhesive pattern for Flat Walls
Adhesive
Pattern
figure 13
Fig.13: Adhesive pattern for
Side Recessed Walls
450
wallboard
recess
wallboard
recess
Tray recess
Pattern on wall board
Page 7
80~100
Tray recess
Pattern on wall board
410
80
Pattern on rear of wall liner
ENGLEFIELD
figure 12
Packing Blocks
*Leave top block intact
to support the shelves.
*Carefully cut the lower
block to t around nog.