Kohler BATH WALL 설치 지침 매뉴얼 - 페이지 7

{카테고리_이름} Kohler BATH WALL에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Kohler BATH WALL 9 페이지. Bath with airjets
Kohler BATH WALL에 대해서도 마찬가지입니다: 러프인 매뉴얼 (4 페이지)

페이지 인쇄

DURACRYL WALL

DURACRYL WALL INSTALLATION CONT...

MARKING ADHESIVE PATTERN

Carefully measure and mark pattern on wall

board surface as shown in figure 11.

This pattern applies to:

Mark the pattern but do not

apply adhesive at this stage.

When applying adhesive

IMPORTANT

it is vital to leave gaps in the

bead to allow solvent curing.

NOTE: Measurements from edges, top and

base. All dimensions below are in millimeters.

For moulded shower walls, the pattern must be marked on both wall board and rear of Duracryl liner.

Refer to ﬁgures below for both patterns: • Corner Contour & Corner Contour PLUS Wall -

At this stage it is essential that the back side of the Duracryl wall and the surface of the wall board

are wiped clean with a damp cloth. This will ensure that all dust is removed from both surfaces and

provide a clean surface for the adhesive. Allow both surfaces to dry before adhesive application.

Fig.12: Adhesive pattern for Corner

Contour and Corner Contour PLUS Walls

300

Tray recess

Pattern on wall board

• Flat shower walls

• Flat bath walls

• The flat sections of

moulded walls

• Side Recessed Wall -

250

Pattern on rear of wall liner

INSTALLATION INSTRUCTIONS

Fig.11: Adhesive pattern for Flat Walls

Adhesive

Pattern

figure 13

Fig.13: Adhesive pattern for

Side Recessed Walls

450

wallboard

recess

wallboard

recess

Tray recess

Pattern on wall board

Page 7

80~100

Tray recess

Pattern on wall board

410

Pattern on rear of wall liner

ENGLEFIELD

figure 12

Packing Blocks

*Leave top block intact

to support the shelves.

*Carefully cut the lower

block to t around nog.