Kohler BATH WALL 설치 지침 매뉴얼 - 페이지 5
{카테고리_이름} Kohler BATH WALL에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Kohler BATH WALL 9 페이지. Bath with airjets
Kohler BATH WALL에 대해서도 마찬가지입니다: 러프인 매뉴얼 (4 페이지)
페이지 인쇄
DURACRYL WALL
CONSTRUCTION REQUIREMENTS - SIDE RECESSED WALL
1) For symmetrical shower enclosures (eg: 1000x1000 corner or 900x900x900 alcove), the acrylic
liner is reversible. Decide on which wall will have the shelving encroach the framing cavity space
and ensure there is no interference or obstructions (eg: plumbing, electrical wires, insulation).
2) Construct timber framing as shown in
Profile shower tray (60-70mm sill height), the Side Recessed Shower Wall Liner is designed to be
compatible with standard 90mm deep framing with vertical studs at 400mm or 600mm centres,
and horizontal nogs at 800mm and 1600mm centres from the floor level. It is recommended that
an additional nog be placed approximately 150mm up from the floor to assist with wallboard fixing.
3) Trial fit the wallboard and mark the cavities to be cut out to allow for the moulded shelving as
shown in figure 5.
4) Carefully cut the wallboard and fix to the studs.
Fig. 5: Wallboard Preparation for Side Recessed Wall Liners
minimum 90mm
stud depth
cutout full height
between nogs
INSTALLATION INSTRUCTIONS
When paired with an Englefield Quick-Fit Low
400mm
(or full width between
studs at 400mm centres)
Page 5
recess for moulded
wall liner shelving
recess for shower tray
ENGLEFIELD