Kohler Command PRO ECV749 Panduan Pemilik - Halaman 6
Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Mesin Kohler Command PRO ECV749. Kohler Command PRO ECV749 21 halaman. Vertical crankshaft
Juga untuk Kohler Command PRO ECV749: Panduan Pemilik (8 halaman)
Halaman Cetak
NOTE: Upon start-up, a metallic ticking may occur.
This is caused by hydraulic lifter leakdown
during storage. The noise will normally cease
in the first minute. If noise continues, run
the engine at mid-throttle for 20 minutes. If
noise persists, take the engine to your Kohler
Engine Service Center.
NOTE: If the starter cranks the engine but does not
start the engine, the engine rotation must be
allowed to come to a complete stop before
attempting to restart the engine. If the starter
is engaged while the flywheel is rotating, the
starter pinion and flywheel ring gear may
clash, resulting in damage to the starter.
If the starter does not turn the engine over, shut off
starter immediately. Do not make further attempts to
start the engine until the condition is corrected. Do
not jump start using another battery (refer to Battery).
See your Kohler Engine Service Center for service
assistance.
Stopping
1. Remove the load by disengaging all PTO driven
attachments.
2. Move the throttle to the slow or idle position; turn
key OFF to stop engine.
Battery
A 12 volt battery is used. Refer to the operating
instructions of the equipment this engine powers for
specific battery requirements.
If the battery charge is not sufficient to crank the
engine, recharge the battery. Follow the battery
manufacturer's instructions.
Operating
Angle of Operation
This engine will operate continuously at angles up to
25°. Check oil level to assure crankcase oil level is at
the F mark on the dipstick.
Refer to the operating instructions of the equipment
6
this engine powers. Because of equipment design or
application, there may be more stringent restrictions
regarding the angle of operation.
NOTE: Do not operate this engine continuously
at angles exceeding 25° in any direction.
Engine damage could result from insufficient
lubrication.
Hot Parts can cause severe burns.
Do not touch engine while operating or
just after stopping.
Cooling
NOTE: If debris builds up on the fixed guard or other
cooling areas, stop the engine immediately
and clean. Operating the engine with blocked
or dirty air intake and cooling areas can cause
extensive damage due to overheating. Refer to
Clean Air Intake/Cooling Areas.
Engine Speed
NOTE: Do not tamper with the governor setting to
increase the maximum engine speed.
Overspeed is hazardous and will void the
engine warranty. The maximum allowable
high idle speed for these engines is 4200 RPM,
no load.
Maintenance Instructions
Normal maintenance, replacement or repair of emission
control devices and systems may be performed by any
repair establishment or individual; however, warranty
repairs must be performed by a Kohler authorized
service center.
WARNING