Kohler Command PRO ECV749 소유자 매뉴얼 - 페이지 6

{카테고리_이름} Kohler Command PRO ECV749에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Kohler Command PRO ECV749 21 페이지. Vertical crankshaft
Kohler Command PRO ECV749에 대해서도 마찬가지입니다: 소유자 매뉴얼 (8 페이지)

페이지 인쇄

NOTE: Upon start-up, a metallic ticking may occur.

This is caused by hydraulic lifter leakdown

during storage. The noise will normally cease

in the first minute. If noise continues, run

the engine at mid-throttle for 20 minutes. If

noise persists, take the engine to your Kohler

Engine Service Center.

NOTE: If the starter cranks the engine but does not

start the engine, the engine rotation must be

allowed to come to a complete stop before

attempting to restart the engine. If the starter

is engaged while the flywheel is rotating, the

starter pinion and flywheel ring gear may

clash, resulting in damage to the starter.

If the starter does not turn the engine over, shut off

starter immediately. Do not make further attempts to

start the engine until the condition is corrected. Do

not jump start using another battery (refer to Battery).

See your Kohler Engine Service Center for service

assistance.

Stopping

1. Remove the load by disengaging all PTO driven

attachments.

2. Move the throttle to the slow or idle position; turn

key OFF to stop engine.

Battery

A 12 volt battery is used. Refer to the operating

instructions of the equipment this engine powers for

specific battery requirements.

If the battery charge is not sufficient to crank the

engine, recharge the battery. Follow the battery

manufacturer's instructions.

Operating

Angle of Operation

This engine will operate continuously at angles up to

25°. Check oil level to assure crankcase oil level is at

the F mark on the dipstick.

Refer to the operating instructions of the equipment

this engine powers. Because of equipment design or

application, there may be more stringent restrictions

regarding the angle of operation.

NOTE: Do not operate this engine continuously

at angles exceeding 25° in any direction.

Engine damage could result from insufficient

lubrication.

Hot Parts can cause severe burns.

Do not touch engine while operating or

just after stopping.

Cooling

NOTE: If debris builds up on the fixed guard or other

cooling areas, stop the engine immediately

and clean. Operating the engine with blocked

or dirty air intake and cooling areas can cause

extensive damage due to overheating. Refer to

Clean Air Intake/Cooling Areas.

Engine Speed

NOTE: Do not tamper with the governor setting to

increase the maximum engine speed.

Overspeed is hazardous and will void the

engine warranty. The maximum allowable

high idle speed for these engines is 4200 RPM,

no load.

Maintenance Instructions

Normal maintenance, replacement or repair of emission

control devices and systems may be performed by any

repair establishment or individual; however, warranty

repairs must be performed by a Kohler authorized

service center.

WARNING