Kohler 1.4BEOR-12V Operasi - Halaman 25

Jelajahi secara online atau unduh pdf Operasi untuk Generator Portabel Kohler 1.4BEOR-12V. Kohler 1.4BEOR-12V 44 halaman. Heavy duty truck mobile generator sets

Halaman Cetak

1. Dipstick

Figure 5-4 Dipstick Location

Check that oil level does not show a reading above

the FULL mark on oil dipstick or to the point of

overflow in reservoir above the FILL mark. See

Figure 5-4.

Check the type of oil grade usage according to engine

startup operating temperatures. See Section 5.3.1,

Engine Oil Selections.

Note: Use of multigrade oil above 0°C (32°F) will

increase oil consumption.

Disabling the generator set.

cause severe injury or death.

generator set or connected equipment, disable the generator

set as follows: (1) Move the generator set master switch to the

OFF position. (2) Disconnect the power to the battery charger.

(3) Remove the battery cables, negative (--) lead first.

Reconnect the negative (--) lead last when reconnecting the

battery. Follow these precautions to prevent starting of the

generator set by an automatic transfer switch, remote

start/stop switch, or engine start command from a remote

computer.

WARNING

Fire.

Can cause severe injury or death.

Do not smoke or permit flames or

sparks near fuels or the fuel system.

TP-6687

9/10

tp6576

Accidental starting can

Before working on the

Servicing the fuel system. A flash fire can cause severe

injury or death. Do not smoke or permit flames or sparks near

the fuel injection system, fuel line, fuel filter, fuel pump, or other

potential sources of spilled fuels or fuel vapors. Catch fuels in

an approved container when removing the fuel line or fuel

system.

5.3.3

Oil Level Check

The recommended oil is AGIP Sigma super TFE

multigrade 10W40 specification API CH-4/CF SL,

ACEA E4, E5, E7, B4. See Section 5.3.1, Engine Oil

Selections. Alternatively, we recommend using Mobil

Delvac 1 SHC 5W40 specification API CF ACEA E4,

B4,B3. Too high an oil level causes high oil consumption

and engine carbonizing.

The 1.4BEOR uses 1.2 L (1.3 qt.) of oil. Too low an oil

level damages the engine. This quantity must be strictly

respected.

1. Make sure the vehicle is on a level surface and the

power unit is stopped.

2. Make sure the power unit has come fully to a halt.

3. Wear special protective gloves and clothing for

maintenance operations.

4. Unlock with the supplied plastic key, the top and

front access panels on the power unit enclosure.

See Figure 5-5.

1. Top access panel lock

2. Top access panel

Figure 5-5 Power Unit Enclosure and Access Panel

Locations

5. Turn the Master Switch (see Figure 5-6) to the OFF

position.

Section 5 General Maintenance

tp6576

3. Front access panel fastener

4. Front access panel