Kohler 1.4BEOR-12V Operasi - Halaman 26

Jelajahi secara online atau unduh pdf Operasi untuk Generator Portabel Kohler 1.4BEOR-12V. Kohler 1.4BEOR-12V 44 halaman. Heavy duty truck mobile generator sets

Halaman Cetak

Top View of Unit

1. Master On/Off switch

2. Oil fill cap

Figure 5-6 Master On/Off Switch and Oil Fill

6. Remove the dipstick and check the oil level. The

right oil level is close to, but not above, the MAX

mark. When the level is below or just above the

MIN mark, it is time to add oil. See Figure 5-4.

7. To add oil, unscrew and remove the oil fill cap and

add the amount of oil needed using a funnel. See

Figure 5-6.

8. Now check the oil level again using the dipstick as

indicated in step 6.

9. After you have correctly checked the level and

refilled with oil, replace the dipstick, insert and

screw on the oil fill cap, and correctly replace the

enclosure access panel, tightening the lock with

the aid of the supplied plastic key.

5.3.4

Oil and Filter Replacement

Replace the oil and oil filter every 500 hours. Contact an

authorized Kohler distributor/dealer. If the unit is used

infrequently, change oil every six months.

Use the following procedure to replace the lubricating oil

and oil filter. Refer to Section 5.3.3 for recommended

oil.

1. Make sure the vehicle is on a level surface and is at

a complete rest.

2. Wear special protective gloves and clothing for

maintenance operations.

3. Contact with used engine oil may cause severe

skin irritation.

Repeated and prolonged skin

exposure may have other health risks.

engine oil is a suspected carcinogen.

contact with skin. Thoroughly wash your hands

and nails with soap and water shortly after handling

Section 5 General Maintenance

Used

Avoid

used engine oil. Wash or dispose of clothing or

rags containing used engine oil. Dispose of used

engine oil in a responsible manner. Contact your

local recycling center for disposal information and

locations.

4. Unlock the top access panel on the power unit

enclosure with the supplied plastic key.

Figure 5-5.

5. Turn the master control switch (see Figure 5-6) to

the OFF position.

6. Unscrew and remove the oil fill cap to make it

easier to empty the oil from the engine.

Figure 5-6.

7. Unscrew the oil drain plug on the bottom of the

power unit in order to drain all the oil from the

engine. When it is completely drained, insert the oil

drain plug and tighten it using a wrench. See

Figure 5-7 and Figure 5-8.

Front View of Unit

1. Oil drain plug

Figure 5-7 Oil Drain Plug Location

1. Wrench

Figure 5-8 Tightening Oil Drain Plug

See

tp6576

TP-6687

9/10