Kohler Englefield Valencia Elite Panduan Petunjuk Instalasi - Halaman 4

Jelajahi secara online atau unduh pdf Panduan Petunjuk Instalasi untuk Perabotan Dalam Ruangan Kohler Englefield Valencia Elite. Kohler Englefield Valencia Elite 7 halaman. Corner sliding 12x9
Juga untuk Kohler Englefield Valencia Elite: Panduan Petunjuk Instalasi (15 halaman), Panduan Petunjuk Instalasi (16 halaman), Panduan Petunjuk Instalasi (14 halaman), Panduan Petunjuk Instalasi (7 halaman), Panduan Petunjuk Instalasi (16 halaman), Panduan Petunjuk Instalasi (17 halaman)

Halaman Cetak
Kohler Englefield Valencia Elite Panduan Petunjuk Instalasi
®
VALENCIA
/ VALENCIA ELITE
( c) For 7 7 29 6 A - * :
To make the installation easier remove the
cabinet door. To release the door hinges press
the buttons at the rear of the hinges.
Button
2 Changing drawer trims (Optional)
NOTE : This section is only applicable if you
have purchased alternate trim for your vanity
cabinet.
( a) After the drawer has been removed (refer
to section 1 ) , unscrew the trim fixing screws
from each angle bracket located behind either
side of the trim.
Angle
brackets
( b) Unscrew the 3 - 4 screws from underneath
the trim and remove the trim from the cabinet.
NOTE : Keep the screws for use later on.
(C) Fix the new trim in place using the screws
that were removed from the original trim.
1278274-A02-D September 2023
®
Single Drawer Vanity
3. Water supply and waste pipe holes
Hook
Trim
Angle
brackets
Page4
INSTALLATION INSTRUCTIONS
( a) Measure and mark the centres for water
supply and waste pipes on the back of the
cabinet.
NOTE : Ensure that plumbing holes are
positioned to allow for a maximum height of
260 mm between the bottom of the basin to
the base of the trap.
Maximum
height
260mm
( b) With a suitably sized hole saw, drill the
holes for the water supply and waste.
( c) Having drilled the required holes fit the
cabinet into position over the pipework.
NOTE: Before fastening the cabinet make
sure that it is sitting level and square.
englefield.co.nz