Kohler Englefield Valencia Elite Kurulum Talimatları Kılavuzu - Sayfa 4

İç Mekan Mobilyaları Kohler Englefield Valencia Elite için çevrimiçi göz atın veya pdf Kurulum Talimatları Kılavuzu indirin. Kohler Englefield Valencia Elite 7 sayfaları. Corner sliding 12x9
Ayrıca Kohler Englefield Valencia Elite için: Kurulum Talimatları Kılavuzu (15 sayfalar), Kurulum Talimatları Kılavuzu (16 sayfalar), Kurulum Talimatları Kılavuzu (14 sayfalar), Kurulum Talimatları Kılavuzu (7 sayfalar), Kurulum Talimatları Kılavuzu (16 sayfalar), Kurulum Talimatları Kılavuzu (17 sayfalar)

Sayfayı Yazdır

VALENCIA

/ VALENCIA ELITE

( c) For 7 7 29 6 A - * :

To make the installation easier remove the

cabinet door. To release the door hinges press

the buttons at the rear of the hinges.

Button

2 Changing drawer trims (Optional)

NOTE : This section is only applicable if you

have purchased alternate trim for your vanity

cabinet.

( a) After the drawer has been removed (refer

to section 1 ) , unscrew the trim ﬁxing screws

from each angle bracket located behind either

side of the trim.

Angle

brackets

( b) Unscrew the 3 - 4 screws from underneath

the trim and remove the trim from the cabinet.

NOTE : Keep the screws for use later on.

that were removed from the original trim.

1278274-A02-D September 2023

Single Drawer Vanity

3. Water supply and waste pipe holes

Hook

Trim

Angle

brackets

Page4

INSTALLATION INSTRUCTIONS

( a) Measure and mark the centres for water

supply and waste pipes on the back of the

cabinet.

NOTE : Ensure that plumbing holes are

positioned to allow for a maximum height of

260 mm between the bottom of the basin to

the base of the trap.

Maximum

height

260mm

( b) With a suitably sized hole saw, drill the

holes for the water supply and waste.

( c) Having drilled the required holes ﬁt the

cabinet into position over the pipework.

NOTE: Before fastening the cabinet make

sure that it is sitting level and square.

engleﬁeld.co.nz