AQC MAXIVIBE AMV-1140 Panduan Pemilik - Halaman 18

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Pengumpul Debu AQC MAXIVIBE AMV-1140. AQC MAXIVIBE AMV-1140 20 halaman.

Halaman Cetak

Shaker type dust collector

Problem

Pressure differential

is too high

Air leaks in the system

Air volume through

the collector is less

Air leaks in the

than original design

collector

Air is minimal or

not sufficient

Temperature is higher

than normal in

collector.

Dust filtered is not

compatible with filter

enveloppe

Presence of humidity

Rapid deterioration

in filtered air

of filter envelope

Incorrect installation

of filter envelope

Abrasion of filter

envelope due to

high inlet velocity

Probable cause

Refer to section above on Pressure differential.

Check doors, ducting and seal leaks.

Examine dust storage section, access doors,

explosion vents and inlets to and from collector.

Seal all leaks.

Check filter envelope (any debris, clogged filter,

obstruction in airflow). Remove or clean.

Check and evaluate filtered air temperature.

Do not exceed such temperatures.

Check for dust properties to be filtered. A.Q.C.

representative or consultant will guide you for

compatible filter. Replace if necessary.

Reduce or modify humidity factor.

Replace filter envelope.

Examine the filter envelope and locate damages

caused by a faulty installation Repair or replace

filter enveloppe if necessary.

Examine the filter envelope for holes or punctures.

If so, install a diffuser at air inlet.

Solution