AQTRONIC THC102MX Panduan Pengoperasian - Halaman 3

Jelajahi secara online atau unduh pdf Panduan Pengoperasian untuk Pengontrol AQTRONIC THC102MX. AQTRONIC THC102MX 5 halaman. Cnc plasma torch height controller

Halaman Cetak

TH102MX

CNC PLASMA Torch Height Controller

COM terminal is a common input terminal connected to the ARC, UP and DOWN

optocoupler contacts inside the device, according to the diagram located on the

cover.

Suggested route is to "GND" at driver/pc end. Do not jumper

this connection to the "7-35V" negative.

OK output is activated when plasma ignition is

detected and after the preset delay countdown. Route and configure for a software

input. Not required to operate.

UP output is activated when the measured voltage is lower than the voltage

setpoints, reduced by half the hysteresis voltage. Route and configure for a

software input.

DOWN output is activated when the measured voltage is higher than the voltage

setpoints, reduced by half the hysteresis voltage. Route and configure for a

software input.

Note: No output signals are activated in case when only the pilot arc is detected

and when the main arc is broken.

Signal outputs should be connected to the CNC system in accordance with the

documentation of the CNC electronic system controlling the machine. For this,

we use inputs of outermost connectors HOME or LIMIT - THC relay contacts

should be connected to the terminals the same way as limit switches connectors.

At the same time, the common COM terminal should be connected to the

CNC system to a common terminal for limit switches (it is usually a GND

terminal).

To reduce the possibility of the short-circuit entering the CNC system, the

connection should be made with a shielded cable - the shielding must be

connected to grounding on the CNC system side. Do not connect the shielding to

the THC controller side.

Start-up and operation:

The device is pre-configured at the factory and after the correct

connections are made, it immediately works properly with most plasma devices.

After switching power on, the THC controller's display displays the Limit value at

left and three dashes at right side"- - - " which means it present there is no input

voltage.

In this mode, by pressing the up/down keys, the threshold value can be modified

and thus set the height of the lens above the material.

To specify other parameters, press menu key,the HYS (hysteresis) parameter is

the first. By press the the menu key again, you can navigate through the menu

parameters. In this state, by pressing the up/down keys you can enter the value

of the current parameter. Once the value is set,wait a moment for automatically

store and exit the menu.

http://www.aqtronic.com