AQTRONIC THC102MX Panduan Pengoperasian - Halaman 4
Jelajahi secara online atau unduh pdf Panduan Pengoperasian untuk Pengontrol AQTRONIC THC102MX. AQTRONIC THC102MX 5 halaman. Cnc plasma torch height controller
Halaman CetakTHC102MX
CNC PLASMA Torch Height Controller
Terminals:
"HYS" (Hysteresis see image 15 page 5) - The hystere-
sis voltage - a range in which the voltage is measured,
in which there are signals controlling UP/DOWN is
deactive.1-15V.Factory setting "1"
"dLy" (delay) - delay time of output OK when the sys-
tem detects the main (cutting) arc
1 - 15 seconds. factory setting: 1s
"CAL" (Calibration) - Due to material deviation the
recorded plasma voltage may need adjustment.
According to an external reference, such as the simple
voltmeter, you can modify the Plasma voltage reading.
-35V to +35V.Factory 0V
"tSt" (Test) - Simulation of the controller's work - the
system simulates the appearance of "floating" Torch
within a countdown timer.By pressing any keys you
can exit from test mode or just wait a few seconds for
auto exit.
4
http://www.aqtronic.com
Jumper configuration: