AQTRONIC THC102MX Bedieningshandleiding - Pagina 4

Blader online of download pdf Bedieningshandleiding voor {categorie_naam} AQTRONIC THC102MX. AQTRONIC THC102MX 5 pagina's. Cnc plasma torch height controller

Pagina afdrukken

THC102MX

CNC PLASMA Torch Height Controller

Terminals:

"HYS" (Hysteresis see image 15 page 5) - The hystere-

sis voltage - a range in which the voltage is measured,

in which there are signals controlling UP/DOWN is

deactive.1-15V.Factory setting "1"

"dLy" (delay) - delay time of output OK when the sys-

tem detects the main (cutting) arc

1 - 15 seconds. factory setting: 1s

"CAL" (Calibration) - Due to material deviation the

recorded plasma voltage may need adjustment.

According to an external reference, such as the simple

voltmeter, you can modify the Plasma voltage reading.

-35V to +35V.Factory 0V

"tSt" (Test) - Simulation of the controller's work - the

system simulates the appearance of "floating" Torch

within a countdown timer.By pressing any keys you

can exit from test mode or just wait a few seconds for

auto exit.

http://www.aqtronic.com

Jumper configuration: