Aqua Cooler CDTT Panduan Penggunaan dan Perawatan - Halaman 4

Jelajahi secara online atau unduh pdf Panduan Penggunaan dan Perawatan untuk Dispenser Air Aqua Cooler CDTT. Aqua Cooler CDTT 13 halaman.

unpacking The WaTer cooler

After unpacking the water cooler, wipe with a soft cloth.

Place the machine on a hard, flat surface. Make certain the unit is level. The unit should not be close

to direct sunlight or other sources of heat.

It is best to place the water cooler in an area with good air circulation. Make sure there is at least 10

cm of space between the back of your cooler and the wall. Keep a minimum distance of 5 cm on each

side of your water cooler.

Warning - The drain cap on the back of the unit may become loose during shipping. Fasten the

drain cap tightly before you start to operate the unit. If the drain cap is loose, the unit may leak and

cause floor damage.

preparing for uSe

This model is different from traditional water coolers. The water bottled does

not need to be placed up-side down on the top of the unit. The water bottle is

placed in the lower cabinet of the unit, and then a pump draws the water up to the

dispenser.

•

Much like a new refrigerator with an ice maker or water dispenser, it is

recommended to run 4 or 8 liters of water through the system before use.

•

Always wash your hands first before handling the water bottle and stainless-

steel siphon tube.

•

Clean the top of the bottle with a clean cloth.

•

A water bottle can be purchased from your local retailer.

adjuSTing The Siphon TuBe

Your new water cooler features an adjustable quick-connect system. For proper operation, make sure

the connector is sealed tightly. (Fig. 1)

The connector can be removed easily for cleaning with warm soapy water. (Fig. 2)

The stainless-steel siphon tube can be adjusted up or down to accommodate a 12 to 19 Liter water

bottle. (Fig. 3)

Fig. 1

Your Partner in Cool.

Fig. 2

Fig. 3