Aqua Cooler CDTT 사용 및 관리 매뉴얼 - 페이지 4
{카테고리_이름} Aqua Cooler CDTT에 대한 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aqua Cooler CDTT 13 페이지.
페이지 인쇄unpacking The WaTer cooler
1.
After unpacking the water cooler, wipe with a soft cloth.
2.
Place the machine on a hard, flat surface. Make certain the unit is level. The unit should not be close
to direct sunlight or other sources of heat.
3.
It is best to place the water cooler in an area with good air circulation. Make sure there is at least 10
cm of space between the back of your cooler and the wall. Keep a minimum distance of 5 cm on each
side of your water cooler.
Warning - The drain cap on the back of the unit may become loose during shipping. Fasten the
drain cap tightly before you start to operate the unit. If the drain cap is loose, the unit may leak and
cause floor damage.
preparing for uSe
This model is different from traditional water coolers. The water bottled does
not need to be placed up-side down on the top of the unit. The water bottle is
placed in the lower cabinet of the unit, and then a pump draws the water up to the
dispenser.
•
Much like a new refrigerator with an ice maker or water dispenser, it is
recommended to run 4 or 8 liters of water through the system before use.
•
Always wash your hands first before handling the water bottle and stainless-
steel siphon tube.
•
Clean the top of the bottle with a clean cloth.
•
A water bottle can be purchased from your local retailer.
adjuSTing The Siphon TuBe
1.
Your new water cooler features an adjustable quick-connect system. For proper operation, make sure
the connector is sealed tightly. (Fig. 1)
2.
The connector can be removed easily for cleaning with warm soapy water. (Fig. 2)
3.
The stainless-steel siphon tube can be adjusted up or down to accommodate a 12 to 19 Liter water
bottle. (Fig. 3)
Fig. 1
Your Partner in Cool.
4
Fig. 2
Fig. 3