Fencee MX10 Panduan Pengguna - Halaman 7

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Pagar & Gerbang Fencee MX10. Fencee MX10 16 halaman. Remote monitoring of fence parameters
Juga untuk Fencee MX10: Panduan Pengguna (16 halaman)

Halaman Cetak

7. PAIRING THE MONITOR WITH THE GATEWAY

First, the MX10 Monitor must be paired with the Gateway in order to display the measured

data. Pairing is performed by the following steps:

The Monitor must be turned off. The LED flashes red.

Then hold the magnet to the Monitor target for >3 s. The Monitor will flash green

and red LED simultaneously. The Monitor is now in pairing mode.

Place the Monitor and Gateway next to each other, up to a maximum distance

of approx. 30 cm.

Now activate the pairing mode also on the Gateway - the exact description is given

in the user manual for the Gateway.

- To select pairing, hold down the MENU button.

- Use the arrow keys to navigate to Pairing and press the ENTER button to access

the Device Manager

- Use the arrow keys to navigate to an empty position

- Press the ENTER button shortly to confirm the item selection

- The correct action is confirmed by the Pairing new device information screen

Upon successful pairing, the Monitor beeps and flashes green. At the same time it also

automatically shuts off so as not to trigger the alarm immediately, because it is not

connected to the fence yet and has no voltage. It is displayed on the Gateway with

a value of 0 kV.

The Monitor is now paired and can be installed on the fence system in the required

measuring point.

The Monitor can only be paired to one Gateway - after pairing with

another Gateway , the previous device will be deleted. The pairing

mode ends automatically after 1 minute or it can be interrupted by

applying a magnet to the target.