Aqua Logic DCS-TI Buku Petunjuk - Halaman 2

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Pengontrol Suhu Aqua Logic DCS-TI. Aqua Logic DCS-TI 5 halaman. Dc series single stage digital temperature control

Halaman Cetak
Installation.
1. Mount control on a wall or any vertical surface that water can't splash on it.
2. Wire the control to heater or chiller.
3. Submerge the titanium temperature sensor in the tank or sump. (DO NOT submerge sensor in
the water beyond the warning label)
Temperature Controller Set-up
T
his digital controller has been pre-programmed with all the necessary parameters to ensure
reliable service and operation. The controller is pre-set from the factory with a temperature range
from 30 °F to 100 °F with a display resolution of 1 degree °F and with a 1 °F temperature
differential.
Temperature Controller Setpoint Set-up
To modify the set point* temperature. Press and release the "SET" button. SP will be displayed.
Press the "SET" button again and the pre-programmed set point temperature will be displayed.
Press the up arrow ▲ to increase or the down arrow ▼ to decrease the set point.
Once the desired set point value has been selected, do not touch any of the keys for 1 minute or
press the "SET" and the "DOWN" ▼ arrow at the same time. The control will then revert to displaying
the current water temperature, but will now control the water temperature to the desired set point.
This indicates that the chiller should be energized
Temperature Differential:
When the water has reached the set point temperature, the chiller will switch off and will not switch back on until the water temperature
has changed by 1 °F. This value is known as the temperature differential between on and off cycles. Refer to the temperature control
parameters table to change the settings.
Display Calibration and Program Parameters
If the displayed water temperature on the control is different from the system water temperature, than an adjustment to the control can
be done. The easiest way to calibrate the control is to press and hold the "Set" button for 8 seconds. The parameter "O" will be
displayed. Wait 4 seconds. Then press the "SET" button and the "SP" will be displayed. Use the down ▼ or up ▲ arrow until you see
the menu parameter "P1". Then press the "SET" button one time. The display will show "0". Press the up or down arrows to adjust to
the temperature offset. Once you have set the correct temperature offset, press "SET" button one more time and then wait 1 minute or
press the "SET" and the "DOWN" ▼ arrow buttons at the same time to quit the programming. The display should return to the water
temperature. The display should read correct water temperature readout.
See page 3 "DC SINGLE STAGE TEMPERATURE CONTROL PROGRAMMABLE PARAMETERS TABLE" to change other settings
To adjust other parameters in the control contact Aqua Logic, Inc. for help.
PH: 858.292.4773 or email: [email protected]
.
Page 2 of 5
Aqua Logic, Inc
9558 Camino Ruiz.
San Diego, CA 92126
PH: 858.292.4773 Fax: 858.292.0537
Website: www.aqualogicinc.com
©Aqua Logic, Inc. 2017