Aqua Logic DCS-TI 사용 설명서 - 페이지 2

{카테고리_이름} Aqua Logic DCS-TI에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Aqua Logic DCS-TI 5 페이지. Dc series single stage digital temperature control

Installation.

1. Mount control on a wall or any vertical surface that water can't splash on it.

2. Wire the control to heater or chiller.

3. Submerge the titanium temperature sensor in the tank or sump. (DO NOT submerge sensor in

the water beyond the warning label)

Temperature Controller Set-up

his digital controller has been pre-programmed with all the necessary parameters to ensure

reliable service and operation. The controller is pre-set from the factory with a temperature range

from 30 °F to 100 °F with a display resolution of 1 degree °F and with a 1 °F temperature

differential.

Temperature Controller Setpoint Set-up

To modify the set point* temperature. Press and release the "SET" button. SP will be displayed.

Press the "SET" button again and the pre-programmed set point temperature will be displayed.

Press the up arrow ▲ to increase or the down arrow ▼ to decrease the set point.

Once the desired set point value has been selected, do not touch any of the keys for 1 minute or

press the "SET" and the "DOWN" ▼ arrow at the same time. The control will then revert to displaying

the current water temperature, but will now control the water temperature to the desired set point.

This indicates that the chiller should be energized

Temperature Differential:

When the water has reached the set point temperature, the chiller will switch off and will not switch back on until the water temperature

has changed by 1 °F. This value is known as the temperature differential between on and off cycles. Refer to the temperature control

parameters table to change the settings.

Display Calibration and Program Parameters

If the displayed water temperature on the control is different from the system water temperature, than an adjustment to the control can

be done. The easiest way to calibrate the control is to press and hold the "Set" button for 8 seconds. The parameter "O" will be

displayed. Wait 4 seconds. Then press the "SET" button and the "SP" will be displayed. Use the down ▼ or up ▲ arrow until you see

the menu parameter "P1". Then press the "SET" button one time. The display will show "0". Press the up or down arrows to adjust to

the temperature offset. Once you have set the correct temperature offset, press "SET" button one more time and then wait 1 minute or

press the "SET" and the "DOWN" ▼ arrow buttons at the same time to quit the programming. The display should return to the water

temperature. The display should read correct water temperature readout.

See page 3 "DC SINGLE STAGE TEMPERATURE CONTROL PROGRAMMABLE PARAMETERS TABLE" to change other settings

To adjust other parameters in the control contact Aqua Logic, Inc. for help.

PH: 858.292.4773 or email: [email protected]

Page 2 of 5

Aqua Logic, Inc

9558 Camino Ruiz.

San Diego, CA 92126

PH: 858.292.4773 Fax: 858.292.0537

Website: www.aqualogicinc.com