DeZurik D10350 Panduan Memulai Cepat - Halaman 7
Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Pemancar DeZurik D10350. DeZurik D10350 9 halaman. Switch and positioner transmitter
Halaman Cetak
Indicator Adjustment
The open-closed indicator on all units, shown in Figure 4 as indicator drum (A4), may be re-indexed on
the input shaft as follows:
1. Remove the two mounting screws and washers near the conduit connection, and lift the unit
from position so that the bottom of the unit is accessible.
2. Loosen the screw (A5) about 3 turns.
3. Pull out the spacer (A6) and shaft adaptor (A1) so that the spacer pins are disengaged from the
timing holes in the indicator drum (A4). (The shaft adaptor may be a different size and/or shape
than shown in Figure 3.)
4. Rotate the indicator drum (A4) to the desired position, and push the shaft adaptor (A1) and
spacer (A6) towards the indicator drum (A4) to engage the spacer pins with the nearest timing
holes in the indicator drum. Tighten the screw (A5) to 8 ± 2 inch pounds.
5. Replace the unit in the same mounting position with the two screws and washers, and tighten
the screws to 80 ± 5 inch pounds.
6. To fine-tune the position of the indicator cover (A3), loosen the set screw (A2), and rotate the
indicator cover to the desired position. Tighten the set screw.
May 2014
Figure 4 - Indicator Adjustment Components
Page 7
DeZURIK
D10350