DeZurik D10350 빠른 시작 매뉴얼 - 페이지 7

{카테고리_이름} DeZurik D10350에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DeZurik D10350 9 페이지. Switch and positioner transmitter

Indicator Adjustment

The open-closed indicator on all units, shown in Figure 4 as indicator drum (A4), may be re-indexed on

the input shaft as follows:

1. Remove the two mounting screws and washers near the conduit connection, and lift the unit

from position so that the bottom of the unit is accessible.

2. Loosen the screw (A5) about 3 turns.

3. Pull out the spacer (A6) and shaft adaptor (A1) so that the spacer pins are disengaged from the

timing holes in the indicator drum (A4). (The shaft adaptor may be a different size and/or shape

than shown in Figure 3.)

4. Rotate the indicator drum (A4) to the desired position, and push the shaft adaptor (A1) and

spacer (A6) towards the indicator drum (A4) to engage the spacer pins with the nearest timing

holes in the indicator drum. Tighten the screw (A5) to 8 ± 2 inch pounds.

5. Replace the unit in the same mounting position with the two screws and washers, and tighten

the screws to 80 ± 5 inch pounds.

6. To fine-tune the position of the indicator cover (A3), loosen the set screw (A2), and rotate the

indicator cover to the desired position. Tighten the set screw.

May 2014

Figure 4 - Indicator Adjustment Components

Page 7

DeZURIK

D10350