DG FPGA Pengaturan - Halaman 7

Jelajahi secara online atau unduh pdf Pengaturan untuk Perangkat Keras Komputer DG FPGA. DG FPGA 20 halaman.
Juga untuk DG FPGA: Pengaturan (5 halaman), Pengaturan (14 halaman), Pengaturan (8 halaman), Pengaturan (10 halaman), Pengaturan (18 halaman)

Halaman Cetak
DG FPGA Pengaturan
dg_toeudp25gip_fpgasetup_xilinx.doc
The step to setup test environment by using FPGA and PC is described in more details as
follows.
1) Connect USB cables between FPGA and PC for JTAG programming and Serial
console/JTAGUART.
a) KCU116 and VCU118 board: Connect two micro USB cables
b) FB2CGHH@KU15P card: Connect one mini USB cable
2) Connect power supply to FPGA development board/FPGA accelerator card.
a) KCU116 and VCU118 board: Connect Xilinx power adapter
b) FB2CGHH@KU15P card: Connect the card to PC or AB18-PCIeX16 board by
following step
i) Confirm that two mini jumpers are inserted at J5 connector on AB18
ii) Connect ATX power supply to AB board
iii) Connect PCIe connector on FPGA board to Device Side (B-Side), as shown in
Figure 2-4
Figure 2-4 AB18-PCIeX16 connection for power supply of FB2CGHH@KU15P card
7-Jun-21
Page 7