AVstumpfl T32-SHIFT Petunjuk Manual - Halaman 8

Jelajahi secara online atau unduh pdf Petunjuk Manual untuk Aksesori Proyektor AVstumpfl T32-SHIFT. AVstumpfl T32-SHIFT 18 halaman. Mobile projection screens

BACK
DISASSEMBLY
For disassembly the same safety instructions apply as for assembly and set up. Bring down a projection
screen with the appropriate number of people to avoid falling over of the screen.
Falling parts can cause severe injury or death!

OPERATION, MAINTENANCE AND SERVICE

FRAME ELEMENTS, LEGS AND ACCESSORIES
The frame elements, legs and additional elements are maintenance-free.
PROJECTION SURFACE
FOLDING AND STORAGE
The projection surface is packed into a separate lined soft bag to avoid any damage by the frame parts,
bleaching and discoloration.
Store the projection surface cleaned and dry at room temperature only!
Identical to the delivery condition, first halve and fold the surface with the projection side inwards on the
shorter side in order to avoid soiling and damage to the surface.
The surface must be folded in such a way that the reinforced black border with the caps is on top of
each other on all sides. Incorrect storage can damage and discolor the surface and is not covered
by the guarantee. When folding the projection surface insert the enclosed foamed plastic foil between
snap buttons and surface to avoid permanent marks.
Additionally, following instructions have to be adhered to:
• Do not allow the projection surface to get in contact with sharp objects!
• Do not bring printed and coloring objects (instructions, magazines, etc.) in contact with the surface!
• Do not write on the projection surface!
• Colors penetrate the projection surface and cannot be cleaned anymore!
COLD BREAK
A projection foil must never be stored or transported below 5° C. There is a risk of a cold break! The
film becomes very brittle and splinters like glass! When transporting the projection surface at low
temperatures do not unfold the surface unless it has reached its full elasticity at room temperature.
Otherwise there is the risk of cold break of the projection screen.
The ideal temperature range for assembling folding screens to prevent damaging the surface is 54°-82°
F (12°-28° C). Assembling below recommended temperatures may damage surface and void warranty
CLEANING OF THE PROJECTION SURFACE
Use a white clean cotton cloth saturated with clear water (optionally mild soap water) and gently
wipe the area in one direction (no circular motion). Wipe dry with another cotton cloth.
To clean a stubborn stain, use methylated spirit and follow the same procedure.
Clean rear projection surfaces in case of imperative only!
8