AVstumpfl T32-SHIFT Instructions Manual - Page 8

Browse online or download pdf Instructions Manual for Projector Accessories AVstumpfl T32-SHIFT. AVstumpfl T32-SHIFT 18 pages. Mobile projection screens

Print Page

BACK

DISASSEMBLY

For disassembly the same safety instructions apply as for assembly and set up. Bring down a projection

screen with the appropriate number of people to avoid falling over of the screen.

Falling parts can cause severe injury or death!

OPERATION, MAINTENANCE AND SERVICE

FRAME ELEMENTS, LEGS AND ACCESSORIES

The frame elements, legs and additional elements are maintenance-free.

PROJECTION SURFACE

FOLDING AND STORAGE

The projection surface is packed into a separate lined soft bag to avoid any damage by the frame parts,

bleaching and discoloration.

Store the projection surface cleaned and dry at room temperature only!

Identical to the delivery condition, first halve and fold the surface with the projection side inwards on the

shorter side in order to avoid soiling and damage to the surface.

The surface must be folded in such a way that the reinforced black border with the caps is on top of

each other on all sides. Incorrect storage can damage and discolor the surface and is not covered

by the guarantee. When folding the projection surface insert the enclosed foamed plastic foil between

snap buttons and surface to avoid permanent marks.

Additionally, following instructions have to be adhered to:

• Do not allow the projection surface to get in contact with sharp objects!

• Do not bring printed and coloring objects (instructions, magazines, etc.) in contact with the surface!

• Do not write on the projection surface!

• Colors penetrate the projection surface and cannot be cleaned anymore!

COLD BREAK

A projection foil must never be stored or transported below 5° C. There is a risk of a cold break! The

film becomes very brittle and splinters like glass! When transporting the projection surface at low

temperatures do not unfold the surface unless it has reached its full elasticity at room temperature.

Otherwise there is the risk of cold break of the projection screen.

The ideal temperature range for assembling folding screens to prevent damaging the surface is 54°-82°

F (12°-28° C). Assembling below recommended temperatures may damage surface and void warranty

CLEANING OF THE PROJECTION SURFACE

Use a white clean cotton cloth saturated with clear water (optionally mild soap water) and gently

wipe the area in one direction (no circular motion). Wipe dry with another cotton cloth.

To clean a stubborn stain, use methylated spirit and follow the same procedure.

Clean rear projection surfaces in case of imperative only!