CPT CPDP-104 Manual Petunjuk Perakitan - Halaman 7
Jelajahi secara online atau unduh pdf Manual Petunjuk Perakitan untuk Alat Listrik CPT CPDP-104. CPT CPDP-104 10 halaman. Circle guide for drill press
Halaman CetakThe Circle Guide tool requires the rotation of material around a Center Pin. Please perform these basic steps
before drilling to prepare your material.
Step 1:
Drill a 1/8" (English) or 3mm (Metric) hole in material which will be the center point of your circle.
Drill the hole as perpendicular as possible to ensure precise rotation around the Center Pins.
Remove any abrasive particles and/or spurs from face of material before rotating to prevent
Step 2:
damage to the surface of the Circle Guide tool.
After preparing the material you can proceed to setting up the Circle Guide and Drill Press.
Step 1:
Start by releasing the Alignment Pin and loosening the Lock-Down Bolt.
Step 2:
Move the Slide Plate away from the drill bit until it is stopped by the Lock-Down Bolt.
Step 3:
Insert the desired drill bit into the Drill Press.
Step 4:
Place material onto the Center Pin through the 1/8" (English) or 3mm (Metric) hole.
Step 5:
Move the Slide Plate into desired position in order to set the radial distance. If using a set
measurement, insert the Alignment Pin into set measurement position and then tighten the Lock-
Down Bolt. If not using a set measurement, simply tighten the Lock-Down Bolt at current position.
Step 6:
Turn on Drill Press and proceed to drilling a hole. Smoothly rotate material when drill bit is raised
to drill holes in circular pattern at the current radial distance. Repeat steps as needed.
Basic Operations
Preparing Material
Drilling Holes in Material (without Degree Gears)