Dell Inspiron 600m Panduan Servis - Halaman 9

Jelajahi secara online atau unduh pdf Panduan Servis untuk Laptop Dell Inspiron 600m. Dell Inspiron 600m 41 halaman. Hard drive
Juga untuk Dell Inspiron 600m: Mulai di sini (2 halaman), Mulai di sini (2 halaman), Mulai di sini (2 halaman), Panduan Memulai (2 halaman), Panduan Pengguna (34 halaman), Setup Manual (2 halaman), Memulai (2 halaman), Setup Manual (2 halaman), Setup Manual (2 halaman), Setup Manual (2 halaman), Setup Manual (2 halaman), Setup Manual (2 halaman), Setup Manual (2 halaman), Setup Manual (2 halaman), Panduan Servis (41 halaman), Panduan Pengguna Media Base (26 halaman), Panduan Servis (40 halaman), Panduan Servis (41 halaman), Menginstalasi dan Mengkonfigurasi (38 halaman), Mulai Cepat (2 halaman), Mulai Cepat (2 halaman), Mulai Cepat (2 halaman), Menyiapkan Komputer Anda (2 halaman), Panduan Servis (4 halaman)

Back to Contents Page

Microprocessor Module

Dell™ Inspiron™ 600m Service Manual

Removing the Microprocessor Module

CAUTION:

NOTICE:

as the back panel) on the computer.

NOTICE:

screw to prevent intermittent contact between the cam screw and microprocessor.

NOTICE:

1. Follow the instructions in

2. Remove the keyboard.

NOTICE:

oils in your skin reduce the heat transfer capability of the thermal pads.

3. Remove the

NOTICE:

4. To loosen the ZIF socket, use a small, flat-blade screwdriver and rotate the ZIF-socket cam screw counterclockwise until it comes to the cam stop.

1 screwdriver (perpendicular

to microprocessor)

2 ZIF-socket cam screw

3 ZIF socket

4 pin-1 corner

NOTE:

The ZIF-socket cam screw secures the microprocessor to the system board. Take note of the arrow on the ZIF-socket cam screw.

5. Lift out the microprocessor module.

Installing the Microprocessor Module

Great user manuals database on

Before performing the following procedures, read the safety instructions in your Owner's Manual.

To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such

Do not touch the processor die. Press and hold the microprocessor down on the substrate on which the die is mounted while turning the cam

To avoid damage to the microprocessor, hold the screwdriver so that it is perpendicular to the microprocessor when turning the cam screw.

"Preparing to Work Inside the

To ensure maximum cooling for the microprocessor, do not touch the heat transfer areas on the microprocessor thermal-cooling assembly. The

microprocessor thermal-cooling

assembly.

When removing the microprocessor module, pull the module straight up. Be careful not to bend the pins on the microprocessor module.

UserManuals.info

Computer."