Avtech RMA-RE1-SEN Catatan Instalasi - Halaman 2
Jelajahi secara online atau unduh pdf Catatan Instalasi untuk Aksesori Avtech RMA-RE1-SEN. Avtech RMA-RE1-SEN 3 halaman. Room entry sensor
Juga untuk Avtech RMA-RE1-SEN: Catatan Instalasi (3 halaman)
Halaman CetakRoom Entry Sensor (RMA-RE1-SEN)
2. Position the magnet (the piece without wires) on the edge
of the door or window so that when it closes, the magnet
closely abuts the proximity switch without actually
touching it. The two pieces may directly face one another
or form a right angle, as shown here, giving you more
installation options.
3. Mount the two pieces securely with screws through their
flange holes, as shown here, or with an adhesive.
Step 4: Connect your Room Entry Sensor to Room Alert.
Do not connect the dry contacts on AVTECH products or other electrical appliances
to any live circuit.
Use only low-voltage 2-wire cable to connect dry contacts.
Configure Your Room Entry Sensor
With Room Alert's Built-In Web Interface
Navigate to
Settings Sensors
below will vary depending on your Room Alert model.
AVTECH Software, Inc.
1. Run the speaker wire from the proximity switch back to your
Room Alert monitor or a Sound, Light & Entry Sensor (SLE).
2. Connect the free ends (the ¼" leads) of the speaker cable to an
open switch sensor port on your Room Alert. Again, the
proximity sensor's leads are non-polarized, so you may connect
either lead to either of the port's dry contacts.
in your Room Alert web interface. The options you see
Page 2 of 3
AVTECH.com