Avtech RMA-RE1-SEN 설치 참고 사항 - 페이지 2

{카테고리_이름} Avtech RMA-RE1-SEN에 대한 설치 참고 사항을 온라인으로 검색하거나 PDF를 다운로드하세요. Avtech RMA-RE1-SEN 3 페이지. Room entry sensor
Avtech RMA-RE1-SEN에 대해서도 마찬가지입니다: 설치 참고 사항 (3 페이지)

페이지 인쇄

Room Entry Sensor (RMA-RE1-SEN)

2. Position the magnet (the piece without wires) on the edge

of the door or window so that when it closes, the magnet

closely abuts the proximity switch without actually

touching it. The two pieces may directly face one another

or form a right angle, as shown here, giving you more

installation options.

3. Mount the two pieces securely with screws through their

flange holes, as shown here, or with an adhesive.

Step 4: Connect your Room Entry Sensor to Room Alert.

Do not connect the dry contacts on AVTECH products or other electrical appliances

to any live circuit.

Use only low-voltage 2-wire cable to connect dry contacts.

Configure Your Room Entry Sensor

With Room Alert's Built-In Web Interface

Navigate to

Settings Sensors

below will vary depending on your Room Alert model.

AVTECH Software, Inc.

1. Run the speaker wire from the proximity switch back to your

Room Alert monitor or a Sound, Light & Entry Sensor (SLE).

2. Connect the free ends (the ¼" leads) of the speaker cable to an

open switch sensor port on your Room Alert. Again, the

proximity sensor's leads are non-polarized, so you may connect

either lead to either of the port's dry contacts.

in your Room Alert web interface. The options you see

Page 2 of 3

AVTECH.com