Dell Dimension 2200 Manual - Halaman 42

Jelajahi secara online atau unduh pdf Manual untuk Server Dell Dimension 2200. Dell Dimension 2200 50 halaman. Vga card installation instructions
Juga untuk Dell Dimension 2200: Manual Penggantian (9 halaman), Petunjuk Instalasi (1 halaman)

Halaman Cetak
Dell Dimension 2200 Manual
Video DAC Snoop
Turns the video DAC Snoop off and on. The default is Off.
The following table shows System Security option information.
 
Option
Function
Password
Locks and unlocks the password option. The default is Unlocked.
Status
System
Enables and disables the system password. The default is Disabled.
Password
Setup Password Enables and disables the setup password. The default is Disabled.
PXE BIS Default
Specifies how the computer will respond to boot integrity services authentication requests when no certificate has been installed. When
Policy
set to Deny (the default), this request is rejected. The request is accepted when set to Accept.

Clearing Forgotten Passwords

CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions in
If you forget your system or setup password, you cannot operate your computer or change settings in the system setup program until you clear the forgotten
password(s).
NOTICE:
This process erases both the system and setup passwords.
1.
 Shut down the
computer.
2.  Turn off any attached devices and disconnect them from their electrical outlets.
NOTICE:
To disconnect a network cable, first unplug the cable from your computer and then unplug it from the network wall jack.
3.  Disconnect the computer power cable from the wall outlet, and then press the power button to ground the system board.
4.
 Remove the computer
cover.
5.  Locate jumper
PSWD on the system board
6.
 Replace the computer
cover, plug your computer into an electrical outlet, and turn on the computer.
The existing password(s) are erased.
7.
 Shut down the
computer.
8.  Turn off any attached devices and disconnect them from their electrical outlets.
NOTICE:
To disconnect a network cable, first unplug the cable from your computer and then unplug it from the network wall jack.
9.  Disconnect the computer power cable from the wall outlet, and then press the power button to ground the system board.
10.
 Remove the computer
cover.
11.  Install the PSWD jumper plug.
12.
 Replace the computer
cover, plug your computer into an electrical outlet, and turn on the computer.
Turning on your computer with the PSWD jumper installed reenables the password feature.
Back to Contents Page
 
 
 
and remove the jumper plug.
"Safety
Instructions."