Dell DL4300 Panduan Penyebaran - Halaman 12

Jelajahi secara online atau unduh pdf Panduan Penyebaran untuk Server Dell DL4300. Dell DL4300 33 halaman.
Juga untuk Dell DL4300: Memulai (2 halaman), Memulai dengan Sistem Anda (2 halaman), Memulai dengan Sistem Anda (2 halaman)

Dell DL4300 Panduan Penyebaran
The AppAssure Appliance Configuration Wizard guides you through the following steps to configure the
software on the appliance.

Configuring the network Interface

Configuring host name and domain settings
Configuring SNMP settings
Rapid Appliance Self Recovery
On completing the installation using the wizard, the Core Console launches automatically.
Configuring the network interface
To configure the available network interfaces:
1.
On the AppAssure Appliance Configuration Wizard Welcome screen, click Next.
The network interfaces page displays the available connected network interfaces.
2.
Select the network interfaces that you want to configure.
NOTE: The AppAssure Appliance Configuration wizard configures network interfaces as
individual ports (non-teamed). To improve ingest performance, you can create a larger ingest
channel by teaming NICs. However, this must be done after the initial configuration of the
appliance.
3.
If required, connect additional network interfaces and click Refresh.
The additional connected network interfaces will be displayed.
4.
Click Next.
The Configure selected network interface page is displayed.
5.
Select the appropriate internet protocol for the selected interface.
You can choose IPv4 or IPv6.
The network details are displayed depending on the internet protocol you select.
6.
To assign the internet protocol details, do one of the following:
To assign the selected internet protocol details automatically, select Obtain an IPV4 address
automatically.
To assign the network connection manually, select Use the following IPv4 address and enter the
following details:
– IPv4 Address or IPv6 Address
– Subnet mask for IPv4 and Subnet prefix length for IPv6
– Default Gateway
7.
To assign the DNS server details, do one of the following:
To assign the DNS server address automatically, select Obtain DNS server address automatically.
To assign the DNS server manually, select Use the following DNS server address and enter the
following details:
– Preferred DNS sever
– Alternate DNS server
8.
Click Next.
The Configure hostname and domain setting page is displayed.
For information on NIC teaming, see
12
Teaming Network
Adapters.