Dell Force10 S25 Series Panduan Konfigurasi - Halaman 3

Jelajahi secara online atau unduh pdf Panduan Konfigurasi untuk Server Dell Force10 S25 Series. Dell Force10 S25 Series 8 halaman. Basic layer 2 setup and buffer tuning of the s25p for storage environments
Juga untuk Dell Force10 S25 Series: Panduan Memulai Cepat (27 halaman)

Halaman Cetak

Dell Force10 S25 Series Panduan Konfigurasi

Setting Up Passwords

Step

Task

Go from EXEC mode to EXEC privilege mode, commonly

called enable mode. After you enter

the prompt changes to: Force10#

Go from EXEC privilege mode to CONFIGURATION mode.

The prompt changes to: Force10(conf)#

Create a password for remote access (through Telnet).

For example, for the username "admin" with password

"admin", enter username admin password admin.

Create a password for access to Command Line Interface

(CLI) modes beyond the EXEC mode. This is typically called

the enable password.

For example, to create the enable password "admin", enter

enable password admin.

The following screenshot illustrates the use of these commands:

Force10>enable

Force10#config

Force10(config)#username admin password admin

Force10(config)#enable password admin

Force10(config)#

You can see the result of setting up a password, or of the other configuration changes that you make by

entering, in EXEC privilege mode,

configuration from its top up to the part that displays the result of using the commands, above:

Force10#show run

Current Configuration ...

! Version 7.8.1.0

! Last configuration change at Wed Oct 27 17:55:30 2008 by default

redundancy disable-auto-reboot stack-unit

hardware watchdog

hostname Force10

enable password 7 b125455cf679b208e79b910e85789edf

username admin password 0 admin

In this case, the password was selected to be encrypted, so the result displayed is encrypted. For details on

setting passwords, see the Getting Started chapter in the FTOS Configuration Guide for the S-Series and

the Security chapter in the FTOS Command Reference for the S-Series.

For details on using the

Command Reference for the S-Series.

101-00337-00

and press Enter,

enable

show running-config

command, see the File Management chapter in the FTOS

show running-config

Command Syntax

enable

config

username name

password password

enable password

password

. The following screenshot shows the running

Command Mode

EXEC

EXEC privilege

CONFIGURATION