Dell Force10 S25 Series Manuale di configurazione - Pagina 3
Sfoglia online o scarica il pdf Manuale di configurazione per Server Dell Force10 S25 Series. Dell Force10 S25 Series 8. Basic layer 2 setup and buffer tuning of the s25p for storage environments
Anche per Dell Force10 S25 Series: Manuale di avvio rapido (27 pagine)
Stampa la pagina
Setting Up Passwords
Step
Task
1
Go from EXEC mode to EXEC privilege mode, commonly
called enable mode. After you enter
the prompt changes to: Force10#
2
Go from EXEC privilege mode to CONFIGURATION mode.
The prompt changes to: Force10(conf)#
3
Create a password for remote access (through Telnet).
For example, for the username "admin" with password
"admin", enter username admin password admin.
4
Create a password for access to Command Line Interface
(CLI) modes beyond the EXEC mode. This is typically called
the enable password.
For example, to create the enable password "admin", enter
enable password admin.
The following screenshot illustrates the use of these commands:
Force10>enable
Force10#config
Force10(config)#username admin password admin
Force10(config)#enable password admin
Force10(config)#
You can see the result of setting up a password, or of the other configuration changes that you make by
entering, in EXEC privilege mode,
configuration from its top up to the part that displays the result of using the commands, above:
Force10#show run
Current Configuration ...
! Version 7.8.1.0
! Last configuration change at Wed Oct 27 17:55:30 2008 by default
!
redundancy disable-auto-reboot stack-unit
!
hardware watchdog
!
hostname Force10
!
enable password 7 b125455cf679b208e79b910e85789edf
!
username admin password 0 admin
In this case, the password was selected to be encrypted, so the result displayed is encrypted. For details on
setting passwords, see the Getting Started chapter in the FTOS Configuration Guide for the S-Series and
the Security chapter in the FTOS Command Reference for the S-Series.
For details on using the
Command Reference for the S-Series.
101-00337-00
and press Enter,
enable
show running-config
command, see the File Management chapter in the FTOS
show running-config
Command Syntax
enable
config
username name
password password
enable password
password
. The following screenshot shows the running
Command Mode
EXEC
EXEC privilege
CONFIGURATION
CONFIGURATION
3